I wanted to use every square and not chop them up into smaller pieces thereby losing potential size of a finished project. So I settled for a very simple layout for a small quilt/wallhanging. All 42 charm squares were laid out as shown above and then I added three rounds of kona snow borders.
This pretty flimsy is the result of some nice, straightforward piecing. Although this nighttime photo doesn't do them justice, I love the colours in this fabric collection, especially the lilacs and mint greens which remind me a lot of some of my favourite summer childhood clothes.
I opted to outline quilt each round 3/8" on either side of the seams and then finished it off with a perfectly co-ordinating piece of lavender flurry.
This little quilt finishes up at 38" x 42.5" which would be quite acceptable if you wanted a pretty wallhanging using your favourite fabric collection of charms or, if you needed a little quilt as a gift in a hurry it really doesn't take too long to make. I will add a few measurements to help you out at the end of the post in case you fancy having a go yourself.
I raided my stash for more backing fabrics for this one and settled on some pale grey solid and soft yellow, both of which are in the Cuzco fabrics though probably not as obviously as the lilacs, green and blue tones of the main collection. This was quite a satisfying quick make and if I had a spare charm pack lying around I would definitely be tempted to try this out again.
So, as promised here are a few pointers to help you stitch up a similar quilt if you take a notion to:
42 - 5" charm squares (Moda pre-cuts already contain all 42)
25" x FWOF of solid border fabrics
10" x FWOF for binding
backing and wadding - needs to be bigger than 38" x 42.5" (a few inches more than 1m of FWOF fabric will be enough)
- Layout charms as shown in top picture of this post.
- Cut solid border fabrics into 4 strips of 2.75" x FWOF (for the two inner border rounds) width and 4 strips of 3.5" x FWOF (for the outer border rounds).
- From each 2.75" solid strip cut a 9.5" strip (for innermost border) and a 23" strip (for middle border). You will have 4 of each.
- Stitch all of your rounds together using 0.25" seam and adding solid strips for each round to the sides first and then to the top and bottom of the quilt.
- When you come to the outer borders, use the 3.5" strips again adding to the sides first and then the top and bottom. Trim the excess.
- Baste and quilt as desired.
- Cut 4 2.5" strips from your binding fabric to bind and finish quilt.
Hope this helps.